xen/docs/misc/hvmlite.markdown

NOTE: this document will be merged into pvh.markdown once PVH is replaced with the HVMlite implementation.

x86/HVM direct boot ABI

Since the Xen entry point into the kernel can be different from the native entry point, a ELFNOTE is used in order to tell the domain builder how to load and jump into the kernel entry point:

ELFNOTE(Xen, XEN_ELFNOTE_PHYS32_ENTRY,          .long,  xen_start32)

The presence of the XEN_ELFNOTE_PHYS32_ENTRY note indicates that the kernel supports the boot ABI described in this document.

The domain builder must load the kernel into the guest memory space and jump into the entry point defined at XEN_ELFNOTE_PHYS32_ENTRY with the following machine state:

• ebx: contains the physical memory address where the loader has placed the boot start info structure.

• cr0: bit 0 (PE) must be set. All the other writeable bits are cleared.

• cr4: all bits are cleared.

• cs: must be a 32-bit read/execute code segment with a base of ‘0’ and a limit of ‘0xFFFFFFFF’. The selector value is unspecified.

• ds, es: must be a 32-bit read/write data segment with a base of ‘0’ and a limit of ‘0xFFFFFFFF’. The selector values are all unspecified.

• tr: must be a 32-bit TSS (active) with a base of '0' and a limit of '0x67'.

• eflags: bit 17 (VM) must be cleared. Bit 9 (IF) must be cleared. Bit 8 (TF) must be cleared. Other bits are all unspecified.

All other processor registers and flag bits are unspecified. The OS is in charge of setting up it's own stack, GDT and IDT.

The format of the boot start info structure (pointed to by %ebx) can be found in xen/include/public/arch-x86/hvm/start_info.h

Other relevant information needed in order to boot a guest kernel (console page address, xenstore event channel...) can be obtained using HVMPARAMS, just like it's done on HVM guests.

The setup of the hypercall page is also performed in the same way as HVM guests, using the hypervisor cpuid leaves and msr ranges.

AP startup

AP startup is performed using hypercalls. The following VCPU operations are used in order to bring up secondary vCPUs:

• VCPUOP_initialise is used to set the initial state of the vCPU. The argument passed to the hypercall must be of the type vcpu_hvm_context. See public/hvm/hvm_vcpu.h for the layout of the structure. Note that this hypercall allows starting the vCPU in several modes (16/32/64bits), regardless of the mode the BSP is currently running on.

• VCPUOP_up is used to launch the vCPU once the initial state has been set using VCPUOP_initialise.

• VCPUOP_down is used to bring down a vCPU.

• VCPUOP_is_up is used to scan the number of available vCPUs.