xen/arm: Use p2m_restore_state in construct_dom0

The address translation functions used while building dom0 rely on certain EL1
state being configured. In particular they are subject to the behaviour of
SCTLR_EL1.M (stage 1 MMU enabled).

The Xen (and Linux) boot protocol require that the kernel be entered with the
MMU disabled but they don't say anything explicitly about exception levels
other than the one which is active when entering the kernels. Arguably the
protocol could be said to apply to all exception levels but in any case we
should cope with this and setup the EL1 state as necessary.

Fu Wei discovered this when booting Xen from grub.efi over UEFI, it's not
clear whether grub or UEFI is responsible for leaving stage 1 MMU enabled.

Use directly the newly created function p2m_restore_state to retrieve a
correct EL1 state to translate an address.

Signed-off-by: Julien Grall <julien.grall@linaro.org>
Reported-by: Fu Wei <fu.wei@linaro.org>
Acked-by: Tim Deegan <tim@xen.org>
Acked-by: Ian Campbell <ian.campbell@citrix.com>

xen/arch/arm/domain_build.c

@@ -1021,14 +1021,7 @@ int construct_dom0(struct domain *d)
         return rc;
 
     /* The following loads use the domain's p2m */
-    p2m_load_VTTBR(d);
-#ifdef CONFIG_ARM_64
-    d->arch.type = kinfo.type;
-    if ( is_32bit_domain(d) )
-        WRITE_SYSREG(READ_SYSREG(HCR_EL2) & ~HCR_RW, HCR_EL2);
-    else
-        WRITE_SYSREG(READ_SYSREG(HCR_EL2) | HCR_RW, HCR_EL2);
-#endif
+    p2m_restore_state(v);
 
     /*
      * kernel_load will determine the placement of the initrd & fdt in