xen/uart: be more careful with changes to the PCI command register

Read the existing PCI command register and only add the required bits to
it, as to avoid clearing bits that might be possibly set by the firmware
already, which might put the device into a non-working state.

Xen being the owner of the PCI device it's legitimately allowed to change
command registers bits.  Be careful however in case buggy devices require
certain command register bits to be enabled, while not strictly required
from Xen's usage.

Fixes: f2ff5d6628 ("ns16550: enable PCI serial card usage")
Signed-off-by: Roger Pau Monné <roger.pau@citrix.com>
Reviewed-by: Jan Beulich <jbeulich@suse.com>

xen/drivers/char/ns16550.c

@@ -283,14 +283,19 @@ static int cf_check ns16550_getc(struct serial_port *port, char *pc)
 static void pci_serial_early_init(struct ns16550 *uart)
 {
 #ifdef NS16550_PCI
+    uint16_t cmd;
+
     if ( !uart->ps_bdf_enable )
         return;
 
+    cmd = pci_conf_read16(PCI_SBDF(0, uart->ps_bdf[0], uart->ps_bdf[1],
+                                  uart->ps_bdf[2]), PCI_COMMAND);
+
     if ( uart->io_base >= 0x10000 )
     {
         pci_conf_write16(PCI_SBDF(0, uart->ps_bdf[0], uart->ps_bdf[1],
                                   uart->ps_bdf[2]),
-                         PCI_COMMAND, PCI_COMMAND_MEMORY);
+                         PCI_COMMAND, cmd | PCI_COMMAND_MEMORY);
         return;
     }
 
@@ -307,7 +312,7 @@ static void pci_serial_early_init(struct ns16550 *uart)
                      uart->io_base | PCI_BASE_ADDRESS_SPACE_IO);
     pci_conf_write16(PCI_SBDF(0, uart->ps_bdf[0], uart->ps_bdf[1],
                               uart->ps_bdf[2]),
-                     PCI_COMMAND, PCI_COMMAND_IO);
+                     PCI_COMMAND, cmd | PCI_COMMAND_IO);
 #endif
 }